Stylus Photo R300/R310 | Revision A |
2.1 Overview
This section describes procedures for disassembling the main components of Stylus Photo R300/R310. Unless otherwise specified, disassembly units or components can be reassembled by reversing the disassembly procedure.
"WARNING" indicates procedures which may result in damage, injury or involving human lives if you don't take extra care.
"CAUTION" indicates precautions for any disassembly or assembly procedures. "CHECK POINT" indicates points to be checked.
"REASSEMBLY" indicates reassembling procedures which are different from the reverse order of the disassembling.
"ADJUSTMENT REQUIRED" indicates required adjustments after the assembly and the disassembly.
Read precautions described in the next section before starting.
2.1.1 Precautions
Before starting the disassembling/reassembling work of this product, always read the descriptions under the following headings "WARNING" and "CAUTION" carefully.
WARNING Disconnect the power cable before disassembling or assembling the printer.
If you need to work on the printer with power applied, strictly follow the instructions in this manual.
Wear protective goggles to protect your eyes from ink. If ink gets in your eye, flush the eye with fresh water and see a doctor immediately.
Always wear gloves for disassembly and reassembly to avoid injury from sharp metal edges.
To protect sensitive microprocessors and circuitry, use static discharge equipment, such as
Never touch the ink or wasted ink with bare hands. If ink comes into contact with your skin, wash it off with soap and water immediately. If you have a skin irritation, consult a physician.
When reassembling the waste ink pads and tray, always make sure that the waste ink tube is fitted correctly in the specified place. Fitting the ink tube in other than the specified position can cause ink leakage.
WARNING Avant de commencer, assure vous que l’imprimante soit eteinte et que le cordon d’alimentation soit debranche.
Veillez a jeter les piles usagees selon le reglement local.
CAUTION Risque d’explosion si la pile est remplacée incorrectment. Ne remplacer que par une pile du même type ou d’un type équivalent recommandé par le fabricant. Eliminer les piles déchargées selon 
les lois et les règles de sécurité en vigueur.
CAUTION When transporting the printer after installing the ink cartridge, be sure to pack the printer for transportation without removing
the ink cartridge.
Use only recommended tools for disassembling, assembling or adjusting the printer. (Refer to Table
Observe the specified torque when tightening screws.
Use the specified lubricants and adhesives. (Refer to Chapter 4 for details.)
Make the specified adjustments when you disassemble the printer. (Refer to Chapter 3 for details.)
DISASSEMBLY AND ASSEMBLY | Overview | 32 |
