Stylus Photo R300/R310

Revision A

†External View

17. Remove the screw which secures "Bushing, Parallel Adjust, Left". Then,

remove "Bushing, Parallel Adjust, Left".

Bushing, Parallel

 

C.P.S (P4) 3x6

Adjust, Right

 

(6-8kgf•cm)

Holder, FFC ; B

Timing Belt

C.P.B (P1) 1.7x5 (1.5-2.5kgf•cm)

18.

Remove "Timing Belt" from "Carriage Unit".

19.

Remove the screws which secure "Holder, FFC; B". Then, remove "Holder,

 

FFC; B".

20.

Remove "Cable, Head" from the connectors of "CSIC Board" and "CR

 

Encoder Sensor Board". Then, remove "Cable Head" from "Carriage Unit".

21.

Release the hooks (x2) from "Holder Pad, Ring" (x2). Then, remove "Holder

 

Pad, Ring" (x2) and "Oil Pad, Ring" (x2).

„Removing "Pulley, Driven"

CR Encoder

Sensor Board

Hooks

Holder Pad, Ring

Oil Pad, Ring

CSIC Board

Connector

Hooks

1.Remove "Extension Spring, 26.46" from "Pulley Driven" and the hook of "Frame, Main" by using a flat-blade screwdriver. Then, remove "Extension Spring, 26.46".

2.Slide "Pulley, Driven" in the direction of the arrow. Then, remove "Frame, Main" from the slot.

„Removing "CR Encoder Sensor Board"

1.Remove the screw which secures "CR Encoder Sensor Board" with Phillips screwdriver (No.0). Disconnect "PW Sensor FFC" from the connector of "CR Encoder Sensor Board". Then, remove "CR Encoder Sensor Board".

Extension Spring, 26.46

Pulley, Driven

2 1

CR Encoder Sensor Board PW Sensor FFC

C.P.B (P1) 1.7x5

 

Connector

 

Slot

(1.5-2.5kgf•cm)

 

 

 

 

 

 

 

 

Figure 2-31. Removing "Carriage Unit" (3)

DISASSEMBLY AND ASSEMBLY

Disassembly

59

Page 59
Image 59
Epson R310 service manual „ Removing Pulley, Driven, „ Removing CR Encoder Sensor Board