EPSON Stylus Photo R300/R310 | Revision A |
9.After finishing PG Adjustment on the right, move "Carriage Unit" to the left edge again, then check PG according to the flowchart in the Figure
Start
11. Check PGs on both the left and right according to the flowchart in the Figure
Start
Check left PG.
Move "Carriage Unit" to
the right by using
Note: Take down toward the printer front by 1 notch: PG gets narrower.
Move "Carriage Unit" to
"Timing Belt".
Does the Thickness Gauge move?
No
Take up toward the printer back by 1 notch: PG gets wider.
Yes
the right by using
"Timing Belt".
Does the Thickness Gauge move?
No
Go to Step 10
Take up: PG gets wider
Take down: PG gets narrower
Take up "Bushing, Parallel |
|
Adjust, Left" toward the |
|
printer back by 1 notch. |
|
Move "Carriage Unit" to |
|
the right by using |
|
"Timing Belt". |
|
Does the Thickness | Yes |
| |
Gauge move? |
|
No |
|
Go Back to Step 7 |
|
Yes
Check right PG.
Move "Carriage Unit" to the left by using "Timing Belt".
Does the Thickness | No |
| |
Gauge move? |
|
Yes |
|
Go to Step 12 | Go Back to Step 3 |
Figure 3-12. PG Checking (2)
Figure 3-11. PG Checking (1)
10.Move "Carriage Unit" back to the left edge of the printer, then set the Thickness Gauge (1.31mm) on the ribs (X3) of "Paper Guide, Front" in the same way as the Figure
12.After finishing the adjustment, screw "Bushing, Parallel Adjust, Left (Right)".
13.After screwing, check PGs on both the left and right again according to the flowchart in the Figure
ADJUSTMENT | Adjustment Except Adjustment Program | 91 |
