Stylus Photo R300/R310

Revision A

†Reinstalling "CSIC Board"

„Check if "CSIC Board" is secured correctly.

†Reinstalling "PW Sensor Board"

„Check if "PW Sensor FFC" is correctly connected.

„Check if "PW Sensor Board" is correctly secured with "Cap, PW Sensor".

†Reinstalling "CR Encoder Sensor Board"

„Check if "CR Encoder Sensor Board" is correctly secured.

„Check if "CR Encoder Sensor Board" is correctly connected.

†Reinstalling "Holder, Scale, Right (Left)"

„Check if "Slider, Holder, Scale" is set.

Slider, Holder, Scale

Figure 2-33. Reinstalling "Slider, Holder, Scale"

† Reinstalling "Carriage Unit"

„Check if "Timing Belt" is correctly set to the installing groove of "Carriage Unit".

„Check if "Grounding Plate, Head" is installed to the proper position of "Carriage Unit".

Grounding Plate, Head

Figure 2-34. Installing Position of "Grounding Plate, Head"

†Reinstalling "CR Scale"

„Make sure that "Extension Spring, 3.289" is not twisted.

„Make sure to pass "CR Scale" through the slit of "CR Encoder Sensor".

„Make sure to install "CR Scale" the cut-part on the left edge up.

Cut-Part

Figure 2-35. Reinstalling "CR Scale"

†Reinstalling "Guide, CR"

„ Screw in the order as shown in the figure.

CAUTION Do not adhere the grease at the contact point of ’Carriage’ and "CR Lock Lever". Otherwise, fatal error may possible occur because ’CR Lock Lever’ is not moved.

DISASSEMBLY AND ASSEMBLY

Disassembly

61

Page 61
Image 61
Epson R310 service manual Slider, Holder, Scale