setroute(8)
System Administration 267
NAME setroute - set routing information for an XSCF network interface
SYNOPSIS setroute -c {add | del} -n address [-m address] [-g address] interface
setroute -h
DESCRIPTION setroute(8) command sets routing information for an XSCF network interface.
Up to eight routing information items can be registered for each network interface.
Any attempt to register more than eight items causes an error.
Privileges You m ust h ave platadm privilege to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-c {add|del} Specifies a function for routing information. One of the following
values can be specified. If none of them is specified, an error
occurs.
add Adds routing information.
del Deletes routing information.
-g address Specifies a gateway address used for routing. To specify address,
use the standard form of four integer values delimited by "."
(periods). For example, use xxx.xxx.xxx.xxx, where xxx is an
integer from 0-255. Zero suppression can be used to specify the
integer.
You cannot specify the loopback address (127.0.0.0/8), the
network address, or a broadcast address.