setroute(8)
System Administration 269
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
■In the following cases, the setroute(8) command results in an error.
■When you tried to set more than eight routing information
■When the netmask that specified by using the -m addr option does not
correspond to any of the cases below:
- Only the most significant bit is 1
- Repeated 1 from the most significant bit
- All bits are zero
■When you set the routing to ISN
■When you set a subnet which is the same with ISN
■When you set a subnet which is the same with DSCP
■On M8000/M9000 servers, when you set the routing to the takeover IP
address
■Only the routing information that has been added by using the setroute(8)
command can be deleted.
interface Specifies the network interface to be set with routing
information. One of the following values can be specified:
■In M3000/M4000/M5000 servers:
For XSCF unit 0:
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
For abbreviation:
lan#0 XSCF-LAN#0
lan#1 XSCF-LAN#1
■In M8000/M9000 servers:
For XSCF unit 0:
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
For XSCF unit 1:
xscf#1-lan#0 XSCF-LAN#0
xscf#1-lan#1 XSCF-LAN#1