setupfru(8)
System Administration 311
NAME setupfru - set up device hardware
SYNOPSIS setupfru [-m {y | n}] [-x {1 | 4}] device location
setupfru -h
DESCRIPTION The setupfru(8) command makes hardware settings for the specified device.
The setupfru(8) command is not supported on the M3000 server.
Only a physical system board (PSB) can be specified as a device. After a PSB is
added, the following settings can be specified for PSB:
Privileges You m ust h ave platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
XSB type To use an added PSB in the system, hardware resources on
the PSB must be logically divided and reconfigured as
eXtended System Boards (XSBs). Two types of XSB are
used: Uni-XSB and Quad-XSB. The Uni-XSB is configured
with undivided PSB, and the Quad-XSB is configured with
one of divided PSB into four parts. Specify either the Uni-
XSB configuration or Quad-XSB configuration for the PSB.
Memory mirror mode In mirror mode, data is mirrored by dividing the memory
mounted on a PSB into two parts. Since the memory is
divided into two parts, the memory capacity is halved, but
data reliability increases. Specify whether to operate the
memory in mirror mode.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-m {y|n} Specifies whether to use the memory mounted on the XSB in
mirror mode. Specify this option when sb is specified for device.
Specify y to enable mirror mode; otherwise, specify n. If the -m
option is omitted, the previous setting is inherited.
-x {1|4} Specifies whether to configure PSB as a Uni-XSB or Quad-XSB.
Specify this option when sb is specified for device. Specify 1 for
Uni-XSB or specify 4 for Quad-XSB. If the -x option is omitted,
the previous setting is inherited.