Accessing SetRAM

1.On the Power Tools Main Window (see page 1-2),tap the SetRAM icon . The SetRAM window displays the current memory distribution.

2.To change the memory allocation, use the slider to adjust the memory allocation: File MB=File Storage Memory

Prog MB=Program Memory

3.Tap Set RAM Allocation to make the change.

4.The terminal launches a hard reset, then a soft reset.

This reset process launches AutoInstall, which launches DeviceConfig’s RAM memory allocation settings. Therefore, make sure that the RAM section is disabled in DeviceConfig.exm or that it contains the same memory settings as SetRAM. For more information, see RAM Memory Allocation in DeviceConfig on page 11-2.

RAM Memory Allocation in DeviceConfig

DeviceConfig contains a RAM section (see page 3-10) that–if enabled–sets the RAM memory allocation for the terminal during startup. Dolphin terminals default to the RAM allocation in DeviceConfig. Therefore, if you want the changes you make in SetRAM to persist through hard resets, make sure that the RAM section in DeviceConfig disabled or, if enabled, matches the parameters in SetRAM.

For more information about DeviceConfig, see RAM Section on page 3-10.

SetRAM Window

Field

Value

Description

 

 

 

 

 

 

 

 

 

Total Installed RAM

128 MB

Actual size of installed RAM chip.

 

 

 

 

 

Memory Statistics:

The values displayed in these fields are pulled from the terminal dynamically when

 

 

SetRAM opens.

 

 

When SetRAM acquires the information successfully, the SetRAM window displays

 

 

the following message: “RAM Info read success.”

 

 

 

 

 

 

 

 

 

11 - 2

Rev A

Dolphin® Power Tools User’s Guide

 

8/6/08

 

Page 162
Image 162
Honeywell 9900 manual Accessing SetRAM, RAM Memory Allocation in DeviceConfig, SetRAM Window, Memory Statistics