HP 958-000290-000 Installing and Configuring Edge Switch 2/32, Summary of Installation Tasks

2

Installing and Configuring

the Edge Switch 2/32

This chapter describes tasks to install, configure, and verify operation of the edge switch 2/32. The switch can be installed on a table or desk top, or mounted in any standard equipment rack.

For a list of the factory-set defaults for the switch and the Reset Configuration option, refer to Appendix B.

Summary of Installation Tasks

Table 2–1summarizes installation tasks for the switch, HAFM server, and Ethernet hub. The table numbers and describes each task, states if the task is required or optional, and lists the page reference for the task. If a task is optional, decision-related information is included.

Table 2–1: Installation Task Summary

Task Number and Description	Required or Optional	Page
Task 1: Verify Installation Requirements	Required	2–3
Task 2: Unpack, Inspect, and Install the	Required	2–4
Switch
Task 3: Configure Network Information	Optional—configure if connecting	2–6
	multiple switches or if connecting a
	switch and HAFM server to a public
	LAN.
Task 4: LAN-Connect the Switch	Required	2–11
Task 5: HAFM Server (Optional)	Optional—if not done, then the switch	2–12
	should be configured using the
	Embedded Web Server (EWS)
	interface.

edge switch 2/32 installation guide 2-1