Installing and Configuring the Edge Switch 2/32
Figure 2–4: HyperTerminal window
9.At the C> prompt, type ipconfig and press Enter. The HyperTerminal window displays with configuration information listed as follows:
—MAC Address
—IP Address (default is 10.1.1.10, factory preset is 10.1.1.10)
—Subnet Mask (default is 255.0.0.0).
—Gateway Address (default is 0.0.0.0)
Only the IP Address, Subnet Mask, and Gateway Address fields are configurable.
10.Change the IP address, subnet mask, and gateway address as directed by the customer’s network administrator. To change switch network addresses, type the following at the C> prompt and press Enter.
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
The IP address is always xxx.xxx.xxx.xxx, the subnet mask is always yyy.yyy.yyy.yyy, and the gateway address is always zzz.zzz.zzz.zzz, where the octets xxx, yyy, and zzz are decimals from zero through 255. If a network address is to remain unchanged, type the current address in the respective field.
When the new network addresses are configured at the switch, the message Request completed OK displays at the bottom of the edge switch 2/32 — HyperTerminal window.
edge switch 2/32 installation guide |
