HP Photosmart C7200 manual 38

(continued)

If you want to:	See this section:
Change the HP All-in-One from a USB	“Change the HP All-in-One from a USB
connection to a network connection.	connection to a network connection”
	on page 47
NOTE: Use the instructions in this section if
you first installed the HP All-in-One with a USB
connection, and you now want to change to
either a wireless or Ethernet network
connection.
View or change the network settings.	“Manage your network settings” on page 48
Find troubleshooting information.	“Network troubleshooting” on page 183

NOTE: You can connect the HP All-in-One to either a wireless or wired network, but not both at the same time.

Finish setup

Wired network setup

This section describes how to connect the HP All-in-One to a router, switch, or hub using an Ethernet cable and how to install the HP All-in-One software for a network connection. This is known as a wired or Ethernet network.

To set up the HP All-in-One on a wired	See this section:
network, you need to do the following:
First, collect all of the required materials.	“What you need for a wired network”
	on page 38
Next, connect to a wired network.	“Connect the HP All-in-One to the network”
	on page 38
Finally, install the software.	“Install the software for a network connection”
	on page 46

Connect to a network 37