10Remove the two screws that secure the media motor to the media"motor mount.

Torx-15

11Pull the media motor towards the rear of the plotter.

12Disconnect the flat encoder cable from the motor, and lift the motor clear of the plotter.

Reassembling: The worm pinion and drive!roller gear mesh slightly during use. Don't install a new motor and an old gear, or vice versa: install the gear that comes with the motor. Apply the grease that comes with the new motor to the worm pinion and drive!roller gear.

Calibration: After having reassembled the plotter, perform the accuracy calibration (Details  chapter 7.)

6"38 Removal￿and￿Replacement

C3187"90000