Removing the Bail Sensor

1

Remove the electronics)enclosure

5 Note the position of the bail)sensor cable

 

cover  page 6)5.

for reassembly. Incorrect positioning

2

Remove the window  page 6)15.

could cause obstruction of the cartridge

carriage and motor gears.

 

 

3Remove the center cover  page 6)16.

4Remove the right endcover  page 6)19.

Bail sensor

6 Disconnect the bail)sensor cable

8 Unclip the bail sensor from its holder,

connector from the main PCA, and from

and lift it, with cable, clear of the plotter.

its ferrite and holding clip on the right

 

sideplate.

Bail-sensor

The ferrite holder opens from the top.

holder

 

 

Bail sensor

 

Bail-sensor

 

 

connector

 

 

Reassembling: The cable goes through

 

 

the same ferrite as for the window￿sensor

 

 

cable  page 6￿24.

 

7

Carefully feed the bail)sensor cable out

Calibration: After having

reassembled the plotter, perform

 

from the electronics enclosure and from

 

the bail calibration  chapter 7.

 

under the motor assemblies.

 

 

C3187)90000

Removal￿and￿Replacement 6)55￿