9.While softly pushing the cam>gear support all the way into the center of the gear, tighten the two screws that attach the cam>gear support to the Y>tensioner bracket.
IMPORTANT: Ensure that the bail>lift mechanism easily performs the engaging and disengaging movement, by pushing the cam gear with your fingers.
10. Tighten the right screw of the Y>tensioner bracket.
11.>Re>assemble the plotter and perform the calibrations in the following order:
a.Cap alignment (chapter 9)
b.Bail calibration (chapter 8)
c.Accuracy calibration (chapter 8)
Administrative Information DRAFT SERVICE NOTEClassification: Modification available
Reason: Serviceability & Reliability Enhancement
Action Category:
Location Category: On>Site
Availability: Product Support Life
Author/Entity: EV/F900
Change in Trailing Cable
Early DesignJet 200 plotters were manufactured with the following trailing cable and associated parts:
DUnshielded Trailing Cable, C3180>60007 (colored white on both sides)
DTrailing>Cable Rear Tray, C3180>00006
DFour Ferrites, 9170>1535
(two inside electronics enclosure, two on trailing>cable rear tray)
DFour Ferrite Clamps, 9170>1533
Later DesignJet 200 plotters, and DesignJet 220 plotters, have a new trailing cable and associated parts, improving electromagnetic compatibility and rendering unnecessary the ferrites on the trailing>cable rear tray:
DShielded Trailing Cable, C3180>60033 (colored white on one side, blue on the other side)
DTrailing>Cable Rear Tray, C3180>00040
DTwo Ferrites, 9170>1535, inside the electronics enclosure
DTwo Ferrite Clamps, 9170>1533
The shielded trailing cable is NOT compatible with old main PCAs (C3180>60101, C3180>68101, C3180>69101).
C3187>90000 | ProductHistoryandServiceNotes 9>13 |