Errors Indicated by LEDs
Error
The Error LED on the front panel works in combination with the other LEDs to specify the type of error that has occurred. The three possible states of any LED are represented like this:
Off |
| On |
|
|
|
| Flashing |
|
|
| |||||
|
|
|
|
|
|
|
|
User Errors
User errors are associated with user settings or user actions and may be solved by the user without calling a Customer Engineer. They are indicated by the Error LED flashing. (Further Information User's Guide, chapter 4, Troubleshooting.)
Error and Cartridges flashing
Error Cartridges
Possible Causes | Corrective Action |
An error was detected during the cartridge4alignment routine.
An error was detected while scanning a setup sheet.
1.Remove the cartridges.
2.Ensure that the protective tape has been removed and that the contacts are clean.
3.Replace the cartridges.
4.If the LEDs do not stop flashing when you lower the window, replace both cartridges with new ones.
See also later in chapter, w Frequent Cartridge Failure.
1.Check the quality of the media and print of the setup sheet.
2.If the quality appears acceptable, try loading the sheet again face down. If not, use a newly printed setup sheet.
3.If the error persists, perform the setup4sheet calibration.
Error and Ready flashing
Error Ready 
Possible Causes | Corrective Action |
The current plot is too large for the plotter's memory
To be able to perform this plot, you have to install more memory. (If the plot is a raster plot, it might work if you send it with a no negative motion RTL command.)
C3187490000 | Troubleshooting 845 |