Removing the Carriage YAxis Motor
1 | Remove the electronics.enclosure | 5 Disconnect the carriage.motor cable from |
| cover page 6.5. | the main PCA (connector labelled Y), and |
|
| from the lowest ferrite holder on the |
2 | Remove the window page 6.15. | right.hand side of the plotter. |
3Remove the center cover page 6.16.
4Remove the right endcover page 6.19.
6 Pressing the small drive belt against the | 7 Loosen the two carriage.motor screws |
tensioner wheel in the belt tensioner to | about 1/2 cm (about 1/4 inch). |
loosen the belt, slide the belt off of the |
|
motor gear; then carefully release your |
|
hand from the the tensioner wheel. |
|
| |
Double pulley |
|
| Loosen |
1 |
|
Tensioner wheel
2
Motor gear
Small drive belt
mn: Ene ha he bel i cecly iined and he caiagem gea and he lwe a f he dble lley
C3187.90000 | RemovalandReplacement 6.35 |