Possible Causes | Corrective Action |
Error Busy
The serial/interface settings are different on the plotter and on the software.
1.Print a setup sheet and check the plotter's current settings for Baud Rate and Parity.
2.Compare these with the current settings of the same two items for your application software. They must be the same.
3.If necessary, change the plotter's settings.
The serial/interface cable is not correctly connected.
The computer is ignoring the plotter's handshake signals.
Connect the cable correctly.
If the computer is using hardware handshake, ensure that the serial/interface cable has a handshake wire.
Error |
|
| Load Media | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Possible Causes | Corrective Action |
The media does not advance around the roller when loaded.
You loaded the media too far from the right side.
The leading edge of the media is not parallel to the roller.
The media is too small for the plotter.
Remove the media and reload it.
Remove the media and reload it, aligning the right edge between the two dashed lines on the loading area.
Reload the media, aligning it correctly.
Use an A/size or A4/size sheet or larger. Load in portrait orientation for setup and align/cartridge routines.
See also later in this chapter, w Problems in Loading Media.
| 8/6 Troubleshooting | C3187/90000 |