Reinstalling the Entry Platen
The order in which you replace the screws on the entry platen is important.
1If the plotter is attached to a support, detach it.
2Turn the plotter on its back.
3Reconnect the media sensor to the entry platen (see also page 6)26).
4Position the entry platen between the two sideplates.
Position the top of the entry platen under all of the small pivots on the inside
of both sideplates, except the back pivot. Rest the entry platen against the back pivot. Position the bottom of the entry platen above the bottom cover of the plotter.
5Replace the indicated screw on the left)hand side. (Long dog)point screw.) Tighten this screw, making sure that the entry platen is aligned tight against the left sideplate.
6Replace the indicated screw on the right)hand side. (Long dog)point screw.)
There must be no space between the entry platen and the left sideplate. It doesn't matter if there is a small space between the entry platen and the right sideplate.
1
2
LEFTHAND SIDE | RIGHTHAND SIDE |
C3187)90000 | RemovalandReplacement 6)67 |