Re,installing Teflon Washers
Normally, you should not have to re,install teflon washers on a DesignJet 200. Instead, you should install a cam,gear support and the associated parts as described later in this chapter. The following note is given in case you need to reassemble the plotter while you wait for these parts to arrive.
Problems can occur if the bail,lift mechanism is too loose or too tight. Typically the number of teflon washers to install is two. However, the ideal reassembly procedure is as follows:
1Re,install the lift mechanism using two washers.
2With the engaging,lever spring installed, press down on the lever and slowly let it rise.
3If the lever does not completely lift up using the spring tension alone, remove one washer.
Teflon
Washers
9,10 ProductHistoryandServiceNotes | C3187,90000 |