What You Should See and Hear
When you turn on the plotter, the following happens:
1All six LEDs light up for a brief moment; then the Busy LED remains on.
If you have activated the extended poweron self tests, all six LEDs remain off for a few seconds before the Busy LED lights up.
2The stepper motor makes a buzzing noise.
3The cartridge carriage knocks against the left3hand side.
4The carriage moves across the plotter and knocks three times against the right3hand side.
5The carriage returns to the left3hand side.
6Any loaded sheet of media is ejected.
7If either cartridge is not correctly positioned, the carriage moves to a position where you can access it; the Cartridges LED lights up indicating that you have to load, reseat or replace the cartridges. (Instructions User's Guide.)
8The cartridges are cleaned in the service station on the left3hand side of the plotter. During the cleaning process, the carriage moves slightly a number of times for the wiper to wipe the nozzles.
9The carriage then parks in the service station on the left3hand side of the plotter.
10If you have loaded or reseated the cartridges, the Cartridges and Load Media LEDs flash, indicating that the first sheet of media that you load will be used to run the cartridge3alignment procedure (Details chapter 7.)
11If the cartridges are already aligned, the Load Media LED lights up to indicate that the plotter is ready for you to load media.
834 Troubleshooting | C3187390000 |