Repair Procedures

Removing the Electronics￿Enclosure Cover

1 Ensure that the plotter is switched off

2 At the back of the plotter, ensure that

and that the power cord and interface

the two small wire clamps of the parallel

cable(s) are not connected to it.

port are positioned vertically.

￿o i￿￿￿￿f￿￿￿

 

 

 

￿￿￿￿￿￿ ￿o￿￿￿￿￿￿￿￿

 

 

 

Power inlet: cord

 

 

 

not connected

 

 

 

3 Remove the screws that attach the

4 Gently lift open the electronics+enclosure

electronics+enclosure cover to the

cover to an angle of 45d.

electronics enclosure.

 

 

￿￿￿￿￿￿￿￿￿ ￿￿￿￿￿￿￿￿ ha￿￿ ￿￿￿￿ ￿c￿￿￿￿￿

 

￿￿￿￿￿￿￿￿￿ ￿￿￿￿￿￿￿￿ ha￿￿ ￿￿￿￿ ￿c￿￿￿￿￿

 

Torx-20

or

Flat

 

C3187+90000

Removal￿and￿Replacement 6+5￿