HP Radio Port 220, Server Performance Pack 200 When to Calibrate the Plotter, Service Mode, ￿n￿e￿￿n￿ ￿e￿￿￿￿e ￿￿de, C3187)90000, 7)2 Calibrations, ￿ Switch the plotter off

When to Calibrate the Plotter

Indications or Repairs Performed	Calibration Required
Jagged lines on plots	Cartridge Alignment
Cartridges are reseated or replaced	Cartridge Alignment
Drive roller is removed or replaced	Accuracy Calibration
Media (X-axis) motor is replaced	Accuracy Calibration
Configuration-plot X-mark distance is not	Accuracy Calibration
500mm ( 1mm)
Carriage or carriage LED is removed or replaced	Cartridge Alignment
	and Setup-Sheet Calibration
Edge-detect failures occur	Cartridge Alignment
Bail failures occur during media loading	Bail Calibration
Bail sensor is removed or replaced	Bail Calibration
Bail-lift mechanism is removed or replaced	Bail Calibration
Media sensor is removed or replaced	Media-Sensor Calibration
Leading and trailing margins of a plot are greater	Media-Sensor Calibration
than 17 mm (0.67 in)
Problems occur scanning a setup sheet.	Setup-Sheet Calibration
EEROM is cleared or main PCA is replaced	(In this order:)
	1. Bail Calibration
	2. Media-Sensor Calibration
	3. Cartridge Alignment
	4. Accuracy Calibration
	5. Setup-Sheet Calibration

Service Mode

￿n￿e￿￿n￿ ￿e￿￿￿￿e ￿￿de

￿ Switch the plotter off.

Align

Cartridges

￿ While holding the Align Cartridges key down, switch the plotter on.

￿Once the Busy LED lights up, release the Align Cartridges key.

T￿￿ ￿￿￿￿￿￿￿ ￿￿￿￿￿￿￿￿ ￿￿￿ ￿￿￿￿￿￿ ￿￿￿￿￿!￿￿ ￿￿￿￿ ￿￿￿￿￿ ￿￿d ￿￿￿￿￿￿￿￿￿￿ ￿￿￿￿￿￿￿￿ ￿￿￿￿￿￿

T￿￿ ￿￿￿￿￿￿￿ ￿￿ ￿￿￿ ￿￿ ￿￿￿￿￿￿￿ ￿￿d￿￿

￿￿￿i￿￿￿￿￿ ￿￿￿ pl￿￿￿￿￿￿￿ ￿￿￿￿ ￿￿￿￿ ￿Draft, Final, Paper ￿￿d Transl/Vellum￿ ￿￿￿￿￿ ￿￿￿￿

￿￿￿ ￿￿￿￿￿ ￿￿￿￿￿￿￿ ￿￿d￿￿ P￿￿￿￿ ￿￿￿ ￿￿￿ ￿￿d ￿￿￿￿ ￿￿￿￿ ￿￿￿￿￿￿￿￿￿

7)2 Calibrations C3187)90000