Removing the Right Endcover
1Remove the window page 6)15, and the center cover page 6)16.
2Remove the two screws on the right front trim and the two screws on the right back trim.
C A U T I O N
Reassembling: When replacing screws on any plastic part, always begin by gently twisting the screw in anticlockwise with your hand, until the screw finds the thread path and clicks, and then twisting the screw in clockwise with your hand, before using a screwdriver. This is to avoid cross)threading. Do not over)tighten the screws.
5Remove the three screws from the right side of the right endcover.
3If the plotter is attached to a plotter stand, loosen the two right)hand screws that attach the plotter to the stand.
4Maintaining an even pressure on the top and bottom of the endcover, pull it to the right, away from the plotter.
C A U T I O N
Do not stress or apply pressure to the front)panel assembly.
Do not let the windowpivot spring drop out of the endcover
mn: Note the upper and lower grooves the endcover engages on the front panel
C3187)90000 | RemovalandReplacement 6)19 |