Removing the Drive Roller

1

Remove the electronics)enclosure

 

C A U T I O N

In the following step, take care

 

cover  page 6)5.

 

not to damage the bail sensor.

 

 

 

2

Remove the window  page 6)15.

 

 

 

14 Remove the three screws that attach the

 

 

3

Remove the center cover  page 6)16.

 

media)motor mount to the right sideplate.

 

 

 

4

Remove the left endcover  page 6)18.

 

￿einst￿lling: Press down on the media

 

mount as you replace the three screws.

 

 

 

5

Lift the left front trim clear of the

 

This is to ensure correct spacing between

 

plotter.

 

the drive roller and the cartridge nozzles.

 

 

 

(Details  chapter 9.)

6Remove the right endcover  page 6)19.

￿￿￿ss ￿￿￿n ￿￿￿￿ ￿s

7 Remove the front)panel￿￿￿ ￿i￿￿￿￿n s￿￿￿￿s assembly  page 6)32.

8Remove the carriage motor  page 6)35.

Torx-20

9 Remove the media motor  page 6)37.

10 Remove the encoder strip  page 6)39.

11 Remove the bail  page 6)56.

12 Remove the service station  page 6)57.

13

Remove the overdrive

Media￿motor mount

 

 

roller  page 6)60.

 

15

Unclip the cables from the holding clip

18 Pull the pinch)arm lever forward to raise

 

underneath the media)motor mount.

the pinch)arm assembly.

16Lift the mount clear of the plotter.

17Remove the screw that attaches the media director to the chassis assembly and remove the media director.

Torx-15

Media director

Pinch-arm lever

C3187)90000

Removal￿and￿Replacement 6)69￿