Enabling patch reading
Enabling the patch code confirmation tone
Cleaning the Patch Reader
Make sure patch reading is enabled before feeding documents.
∙Patch reading may be enabled or disabled at the mode level using function code F50.
If you have enabled patch reading, but do not want to read a patch found on the next document only, perform function code F54.
The patch code confirmation tone may be used to signal that a patch has been read.
∙If your machine is configured for no confirmation tones, then no confirmation tones of any kind will be heard in any mode.
∙If your machine is configured to allow confirmation tones, then you can disable (or enable) confirmation tones in any mode as desired.
∙If the machine confirmation tones and the patch code confirmation tone are enabled during installation for the mode being used, you may enable/disable the patch code confirmation tone during normal operations by performing function code F53.
NOTE: In addition, a patch/bar code confirmation tone may be used to signal that both a patch and a bar code and have been detected. This confirmation tone may be enabled or disabled by performing function code F62.
Periodically wipe the sensor at the end of the Patch Reader with a dry, lint- free cloth.
Sensor
|
