Operating keys and indicators
Key/Indicator
Clear/Cancel
Run
NEXT
Stop
Enter
Function
The C key allows you to:
∙Cancel a function without changing the preset values.
∙Clear the status display after executing specified function codes.
∙Clear an operator message from the status display.
Turns on the feeder and transport system.
Allows you to enter the next document image address.
Allows you to stop the feeder and transport system. Documents still in the transport system will be scanned and placed in the exit hopper before the transport system stops.
Enters data for a function code or an image address change.
Confirmation tone/alarm The confirmation tone/alarm is located under the control panel and sounds when one of the following conditions occur:
∙Run is pressed (one long tone).
∙Stop or End is pressed (many short tones followed by a long tone).
∙Feeder clutch engages/disengages (one short tone).
∙Incorrect key is pressed (three short tones).
∙Document skew is greater than what is setup in the skew parameter, or when a document is shorter or longer than the specified length parameters (one short tone).
∙A bar code is detected (if the accessory is enabled and the confirmation tone is enabled).
∙A patch code is detected (if the accessory is enabled and the confirmation tone is enabled).
∙The Footswitch is detected (if the accessory is enabled and the confirmation tone is enabled — one short tone).
|
