Kodak A-61092 manual Operating the Scanner, Overview

3 Operating the Scanner

Overview

This chapter provides instructions for selecting modes, using temporary operating values and feeding documents using either the semi- automatic feeder or the automatic feeder.

The scanning process consists of the following steps:

1.Prepare the scanner for operation (refer to Chapter 2, Getting Started for more information.)

2.The scanner is enabled by the host system.

3.Select a mode for the application. Typically the host computer performs this step, but it may also be performed by the operator.

4.Select temporary operating values (if required).

5.Press the Run key.

6.Feed documents into the transport (refer to Feeding Documents using the semi-automatic(or automatic) feeder later in this chapter).

∙The scanner assigns a sequential ID number (for digital image storage), the document image level and image address.

∙The document is scanned.

∙The document image header is created.

∙The host computer initiates transfer of the document image header and document image to the host system for storage on magnetic or optical disk media.

∙Documents are deposited in the exit hopper, face down, in the order in which they were fed into the transport.

7.Press the Stop key.

8.Press P2 or enter function code F38 to indicate end-of-job.

9.Turn off the side panel switch.

NOTE: If the scanner will not be used for 8 hours or more, turn off the main power switch.

A-61092 September 1999 3-1