4 Function Codes

Using function codes

There are a variety of functions available which may be used to temporarily change operating parameters, and to obtain system and accessory status information.

These functions are listed in the Function Code Summary later in this chapter. Following are the procedures for using function codes:

1.Press the F key.

2.Press the numeric keys which correspond to the desired function code.

3.Press Enter.

If the function is used to enable or disable an operation (turn an option on or off):

1.Press 1 to turn the option On, or 0 to turn the option Off.

2.Press Enter.

If the function requires numeric input:

1.Press the numeric key(s) required.

2.Press Enter.

If the function is used to increment or decrement a measurement or setting:

Press the arrow keys to increment or decrement as follows:

Press the Up arrow to increment the measurement by

1inch (25 mm) or one value, or

Press the Down arrow to decrement the measurement by

1inch (25 mm) or one value, or

Press the Right arrow to increment the measurement by 1/8-inch (3 mm) or one value, or

Press the Left arrow to decrement the measurement by 1/8-inch (3 mm) or one value.

Press Enter.

To cancel a function (before pressing Enter) or clear the status display after executing a function code:

Press C (Clear/Cancel).

A-61092 September 1999

4-1

Page 26
Image 26
Kodak A-61092 manual Function Codes, Using function codes