Before you begin
Changing the die drum
Before feeding documents requiring an endorsement, verify the following:
1.The correct die drum is installed.
2.A new ink roller is installed (if print quality is not acceptable).
3.The correct date and code number is specified.
4.The feeder side guides are properly positioned to place the endorsement where it is required on the documents.
5.The Endorser is enabled.
6.The correct Endorser print position is specified.
7.The desired Endorser mode is selected.
Once each of these items has been verified, you may begin feeding documents.
The die drum may need to be replaced after extensive use or if a different die style is required.
NOTE: If a number of special die drum assemblies have been purchased, simply remove and replace the entire assembly with the required one.
To replace a die:
1. Open the top cover.
Top cover
|
