Code
E121
E122
E123
E124
E125
E126
E127
E128
E130
E131
E132
E133
E140
E141
E142
E143
E145
E200
E201
Operator Message Displayed
Check front patch reader
Check rear patch reader
Command data rejected — resend
Command not allowed in this model
Enter correct command
Feeder waiting for host system
Feeder adjustment warning
OCR not installed
Device not enabled
Enable bar code first
Feeder waiting for printer (Super 12 Printer only)
Document Printer not installed Patch Reader not installed Detection System not installed Bar Code Reader not installed Endorser not installed
Verify/enter image address
Description/Action Required
Patch code not recognized.
Verify that the patch document was fed into the transport in the proper orientation.
∙If not, refeed the path document.
∙If so, change to a
Command not recognized. Enter the command again.
Command cannot be performed. Enter a valid command.
Press correct key(s) for mode selected.
System is busy. No action required. Wait for the message to clear.
Check and adjust feed and separator roller gap.
Requested action requires installation of the OCR accessory.
Requested action requires installation of the Bar Code Reader.
Requested action requires that you enable the Bar Code Reader. Enter function code F60 to enable bar code reading.
The printer is moving into the print position; wait until the message clears.
Requested action required installation of the module/accessory indicated.
The required module/accessory is not installed.
An error has occurred in the system and the image address may no longer be correct.
Use function code F08 to determine the last image address.
Use the Next key to correct the image address, if necessary.
