Adjusting the feed shelf position (semi-
automatic feeder only)
11.When you have adjusted the gap so the bottom document separates consistently from the top document, rotate the gap adjustment knob counterclockwise another 1 or 2 clicks to complete the adjustment.
12.Feed a stack of 50 to 100 documents twice through the transport system. Verify the final count reflects the total number of documents fed and that the counter shows the same amount each time the documents are counted.
If the count is not the same, the gap is not adjusted correctly. Rotate the gap adjustment knob counterclockwise another 1 or 2 clicks and repeat Step 12. Repeat until corrected.
13.Press Stop.
14.Enter function code F04 and disable Counting Only.
15.Press Enter.
Before you begin feeding documents into the scanner, adjust the position of the feed shelf.
Feed shelf
Work shelf
Notch
Groove
Height adjustment legs
To automatically feed multiple documents, the feed shelf should be in the raised position (as shown above).
To raise the feed shelf:
1.Grasp the notch and lift the feed shelf.
2.Swing the height adjustment legs out and insert them into the groove on the work shelf.
To
To lower the feed shelf:
1.Grasp the notch and lift the feed shelf until the height adjustment legs are no longer resting in the groove on the work shelf.
2.Tuck the height adjustment legs in and lower the feed shelf into position.
|
