Clearing jams in the check feeder
To clear a document jam in the check feeder, perform the following procedure:
1.Check the
2.Remove the feeder top cover by carefully lifting up at the front edge and pulling it toward the front of the unit.
3.Open the front cover.
4.Raise the baffle plate until it locks into position.
Baffle plate
Tab
Tab
Feed assembly roller
5.Press the two tabs inward and rotate the feed roller assembly backward.
6.Remove any documents from this area.
7.Rotate the feed roller assembly forward until it locks into place.
8.Close the baffle plate by lifting up and then lowering it into place.
9.Close the front cover.
10.Replace the feeder top cover by placing it back in position directly under the front cover and sliding it forward until it is squarely in place. Lower the feeder top cover until it snaps shut.
After clearing a document jam, perform the following procedure:
1.Make certain the baffle plate, doors, and panels are securely closed and the imaging guides are in the proper position.
2.Press and hold the Jog key, which will move any remaining documents through the transport system and place them onto the check stacker.
3.Feed retrieved documents again.
|
