7.Remove the rubber die by carefully prying it off. Insert a new rubber die in place of the old one. Ensure that it engages the spring clips at both sides. (If an entire die drum assembly is available to replace the die, this is not necessary.)
Die
Spring clip
(Pry off at this edge)
8.Reinstall the die drum assembly by inserting the shaft, aligning the die, and directing the shaft into the mounting holes and the slot.
9.Raise the drum locking lever to secure the die drum assembly.
10.Rotate the Endorser toward the front of the unit. The latch will automatically lock the Endorser in place.
11.Lift the locking lever to secure the Endorser.
12.Close the top cover.
13.Feed several blank pages to allow the new die to be properly inked.
