Enabling the
Endorser
Changing the print position
Selecting the Endorser mode
7.Repeat the two previous steps until all of the fields are set.
NOTE: Make sure that all characters on the drum are in line, flat and not off center so the ink will be picked up evenly for a high quality endorsement.
8.Slide the date knob back into the locked or run position (as indicated on the index plate).
9.Rotate the Endorser toward the front of the unit. The latch will automatically lock the Endorser in place.
10.Lift the locking lever to secure the Endorser.
11.Close the top cover.
Make sure the Endorser is enabled prior to feeding documents. The Endorser may be enabled or disabled at the mode level using function code F57.
The Endorser print position specifies how far from the leading edge (fed into the transport first) of the document the endorsement will be printed. The print position may be changed using function code F59. This function allows you to temporarily change the Endorser print position. The new print position will be used to print endorsements until function code F02 (Restore Mode) is used to return the print position to its original value (provided that mode overrides are not saved), or until function code F59 is used again to change the Endorser print position.
NOTE: The Endorser print position should be carefully calculated. Make sure to set the Endorser print position close enough to the leading edge (fed into the transport first) of the document so the printed information does not extend beyond the trailing edge of the document.
The Endorser mode determines whether the Endorser prints one endorsement per document (single stamp) or continuous endorsements (continuous). The Endorser mode may be specified using function code F58.
