6 Operator Messages

This chapter outlines the actions that should be taken by the user and system administrator when an operator message appears in the status display.

If a message appears in the status display that is within the ranges E000-E299 or E500-E599, you should take the action indicated in the table(s) in this chapter.

IMPORTANT: Never power down the machine without first contacting your system administrator.

If a message appears in the status display that is within the ranges E300-E499 or E600-E999, contact your system administrator.

The following action(s) should be taken:

Determine whether or not the error can be addressed from the host system.

If the error cannot be addressed from the host system, attempt to clear the error by taking the action indicated in the table(s) in this chapter.

If the prescribed action(s) does not clear the error, initiate a controlled power-down sequence:

Wait for all information currently held in the buffer to be transferred to the host system.

Turn off the scanner transport using the side panel switch.

Turn off the scanner power using the main power switch.

Wait 10 to 30 seconds.

Turn on the scanner power using the main power switch.

Turn on the scanner transport using the side panel switch.

If the error condition is not cleared using the controlled power-down sequence, contact service.

A-61092 September 1999

6-1

Page 54
Image 54
Kodak A-61092 manual Operator Messages