6. Turn the gap adjustment knob counterclockwise 2 1/2 turns.
Gap adjustment knob
Separated document
Gap
(between feed and separator rollers)
Feed rollers
Trailing edge of top
document
7.Select two documents of the same size, texture and thickness, similar to the types of documents you will be processing.
8.Place one document on top of the other. Hold the documents firmly by their trailing edges. Insert them into the gap approximately 1/8 in. (3 mm).
If the documents separate, repeat the following steps until the documents do not separate:
∙Turn the gap adjustment knob clockwise 1/2 turn.
∙Insert the documents again.
If the documents do not separate, proceed with Step 9.
9.Rotate the gap adjustment knob counterclockwise 1 or 2 clicks.
10.Hold the trailing edges of the documents firmly. Insert them into the gap.
∙If the bottom document is not separating from the top document, remove the documents and repeat Steps 9 and 10 until the bottom document separates from the top document by approximately 1 in. (25.4 mm).
∙If the bottom document is separating from the top document, proceed with Step 11.
|
