Using the Display option
Using the %KODAK option
The Display option allows you to display the decoded value of an individual bar code as it is fed into the transport. After selecting Option 2, DISPLAY, feed a bar code document.
To verify that a bar code is decoded properly:
1.Select 2=DISPLAY.
Bar Code Type =
1=EVALUATE 2=DISPLAY 3=%KODAK 4=%NORM One of the following messages will be displayed:
∙Bar code was not read.
If the display indicates the bar code was not read, it could be for one of the following reasons:
◊The type of bar code read was not the type indicated in the status display.
Action: Verify the type of bar code read.
◊The bar code quality is poor.
Action: Perform the required maintenance.
∙?
This display indicates the start character was recognized, but the remainder of the bar code was unreadable.
Action: Perform the required maintenance.
∙Decoded bar code value
This display gives the decoded value of the bar code read.
2.When the test is completed, press C to return to normal operation, or press Stop to remain in the test environment.
The %KODAK test option establishes the percentage of bar codes properly read when using Kodak Bar Code Standard Test Documents. This option is designed to provide a baseline value as well as the current read rate. A comparison of the two values provides a measure of machine performance over time.
To use the %KODAK test option:
1.Select 3=%KODAK.
Bar Code Type =
1=EVALUATE 2=DISPLAY 3=%KODAK 4=%NORM
2.Feed at least 100 Kodak test documents. As documents are fed into the transport, the Kodak documents fed value will increment.
Kodak documents fed = 100 Current = xx.x% Historical = xx.x%
|
