Code

E281

E282

E285

E286

E291

E293

E294

E295

E296

E297

E298

Operator Message Displayed

OCR was reset — restart batch

Comm buffer full — please wait

Feeder off due to OCR request

Feed calibration target

Scanner disabled

Host recovery required

Front calibration warning

Rear calibration warning

Target not seen

Document queue full

Calibration required

Description/Action Required

Use the Next key to enter a starting image address.

Rerun the batch.

System is busy. Wait until the message clears, then continue.

System is busy. Feeder will be reactivated when the system is no longer busy.

Wait until the message clears, then continue.

Calibration process has started.

Press Run and feed the calibration target into the transport.

The machine has been disabled due to an error. Determine the cause of the error via the host system.

Enable the machine.

Press Run to continue.

Contact your system administrator to initiate the required action on the host system.

Perform maintenance/cleaning procedures for the Document Scanning Array, imaging guides, etc.

Check the lamps; replace if necessary.

Recalibrate the machine.

Perform maintenance/cleaning procedures for the Document Scanning Array, imaging guides, etc.

Check the lamps; replace if necessary.

Recalibrate the machine.

Repeat the calibration process using a blank target. If error repeats, call service.

The feeder and transport are stopped and the machine is disabled.

Transfer images from the image buffer to the host system.

Re-enable the machine.

Press Run to continue.

Enter function code F37 to initiate the calibration sequence.

6-6

A-61092 September 1999

Page 59
Image 59
Kodak A-61092 manual E281 E282 E285 E286 E291 E293 E294 E295 E296 E297 E298