Troubleshooting & Maintenance

Lexicon

TROUBLESHOOTING

Incorrect operation is sometimes mistaken for malfunction. If problems occur, refer to this section for troubleshooting information or visit www.lexicon.com for additional troubleshooting information and answers to frequently asked questions. If problems persist, contact Lexicon Customer Service at 781-280-0300 or www.lexicon.com.

POWER ISSUESThe RT-10 will not power on.

1.Power the RT-10 on with the front panel On/Off button.

2.Deactivate standby mode. If the RT-10 is not configured for trigger control, press the remote control POWER button to deactivate standby mode. If the RT-10 is configured for trigger control, use component connected to the RT-10 trigger input connector to deactivate standby mode.

3.Make sure the power cord is connected to the AC input connector and the electrical outlet.

Standby mode automatically activates.

1.Set the AUTO_P parameter (3-52) to OFF. When this parameter is set to On, the RT-10 automatically activates standby mode after 30 minutes of non-use.

REMOTE CONTROL ISSUESThe remote control seems to stop working.

1.Make sure the remote control batteries are correctly inserted with the proper polarity (1-9).

2.Replace the remote control batteries (1-9). The remote control requires two AA batteries that should be replaced as needed. It is strongly recommended to use Alkaline batteries, which last longer without leaking.

3.If the RT-10 is not using the IR IN connector, make sure the remote control is in line-of-sight with the front panel display remote control sensor. Eliminate obstructions between the remote control and the remote control sensor. The remote control might become unreliable if strong sunlight or fluorescent light is shining on the remote control sensor.

4.Make sure the remote control is positioned within its operating range (2-14). The remote control should be positioned at a 30-degree angle no more than 17 feet (5m) from the RT-10. If the RT-10 is placed inside a glass cabinet, smoked glass might reduce the remote control range.

5.Make sure the same command mode (3-53) is assigned to the remote control and the RT-10. The remote control can only be used to operate an RT-10 to which the same command mode is assigned. The remote control cannot be used to operate an RT-10 to which a different command mode is assigned, except to configure Advanced Setup menu parameter settings.

6.If playback is activated, press the Stop button to activate stop mode, then press the Play button to activate playback from the beginning of the loaded disc. In some cases, this will restore functionality.

7.Power cycle the RT-10 with the front panel On/Off button. In some cases, this will restore functionality.

5-2