RT-10

The remote control number buttons cannot be used to enter values 10 and above.

1.In some cases, the remote control +10 button must be used to enter values 10 and above. Press the +10 button once for numbers in the teens, twice for numbers in the twenties, and so on. Then, press the desired number button (0 to 9) to enter the second digit. For instance, entering a value of 25 requires a remote control command sequence of +10, +10, and 5.

VIDEO OUTPUT ISSUESThe RT-10 is powered on, but there is no video.

1.Examine the rear panel to ensure that the required video output connection (2-11) has been made and that video cables – particularly S-video cables – have been fully inserted.

2.Make sure all associated components are powered on and configured with the correct settings.

3.If the V OFF indicator appears on the front panel display, press the remote control VIDEO ON/OFF button to reactivate the video output connectors.

4.If the RT-10 has a component video output connection and the associated display device is not progressive-scan compatible, set the Component Video parameter (3-27) to Interlace or reconnect the RT-10 to the associated display device with an

S-video or composite video output connection.

Troubleshooting & Maintenance

The picture on the associated display device screen appears stretched or otherwise distorted.

1.Set the TV Type prompt (3-5) or TV Screen parameter (3-25) to the appropriate setting for the associated display device.

2.Make sure all associated components – particularly display devices – are configured with the correct settings.

3.Press the remote control SETUP button to close the Setup menu. When the Setup menu is open while the TV Type prompt (3-5) or TV Screen parameter (3-25) is set to a 4:3 format, the screen automatically adjusts to 16:9 format (widescreen) to accommodate the Setup menu. When the Setup menu is closed, the screen automatically reverts to the selected 4:3 format.

4.Make sure the loaded disc allows video output format (aspect ratio) adjustments.

The picture on the associated display device screen includes video artifacts.

1.Stop executing commands. Depending on the format of the loaded disc, some commands might cause the picture to disappear or shake.

2.If the RT-10 has a component video output connection and the Component Video parameter (3-27) is set to Progressive, set the parameter to Interlace.

3.The loaded disc might include a copy-prevention signal (1-6). The RT-10 is compatible with Macro-Vision System copy guard. However, some discs include a copy prevention signal that produces video artifacts such as stripes in the picture.

. . . Video Output Issues continues on page 5-4

5-3