RT-10

Setup Menus

REMOT_CODE

DVD_1, DVD_2

Assigns a remote control command mode to the RT-10. When DVD_1 is selected, the RT-10 can be operated with an RT-10 remote control to which the DVD_1 command mode is also assigned. When DVD_2 is selected, the RT-10 can be operated with an RT-10 remote control to which the DVD_2 command mode is also assigned.

Assigning Remote Control Command Modes

The RT-10 remote control can be used to operate two RT-10s installed in the same system when the DVD_1 command mode is assigned to one RT-10 and the DVD_2 command mode is assigned to the other RT-10. These command modes can also be assigned to the remote control, allowing the remote control to operate an RT-10 to which the same command mode is assigned. The remote control cannot be used to operate an RT-10 to which a different command mode is assigned, except to configure Advanced Setup menu parameter settings.

Note:

The DVD_1 command mode is intended for use when two RT-10s are installed in the same system. Otherwise, avoid assigning the DVD_1 command mode to the RT-10 and the RT-10 remote control.

When one RT-10 is installed in the system, follow the instructions in the next column to assign the DVD_2 command mode to the remote control and the RT-10. The DVD_2 command mode is assigned to the RT-10 when factory-default settings are restored. The command mode assigned to the remote control is not affected when factory-default settings are restored.

When two RT-10s are installed in the same system, follow the instructions below to assign the DVD_1 command mode to one RT-10 and the DVD_2 command mode to the other RT-10. Follow the instructions below to toggle the command mode assigned to the remote control, allowing the remote control to provide independent operation of both RT-10s.

To assign the DVD_2 command mode to the remote control:

Press and hold the remote control STOP and number 2 buttons for about 5 seconds.

To assign the DVD_1 command mode to the remote control:

Press and hold the remote control STOP and number 1 buttons for about 5 seconds.

To confirm the command mode assigned to the remote control:

Press and hold the remote control STOP and PAUSE buttons for about 2 seconds. The command mode assigned to the remote control will appear on the front panel display.

To assign a command mode to the RT-10:

Follow the navigation instructions on the previous page to set the REMOT_CODE parameter to the desired command mode.

3-53