Getting Started
Figure A | Figure B | Figure C |
The remote control requires two AA batteries that should be replaced as needed. It is strongly recommended to use Alkaline batteries, which last longer without leaking.
To replace the remote control batteries:1.Locate the battery compartment on the back of the remote control. Then, remove the battery compartment cover as shown in Figure A (above). To do this, press the tab attached to the cover. When the tab is pressed, pull the cover away from the remote control.
2.Remove and dispose of old batteries inserted in the compartment (if applicable).
3.Insert two AA batteries in the compartment as shown in Figure B (above). Make sure the batteries are correctly inserted observing the proper polarity.
4.When new batteries have been inserted, close the battery compartment cover as shown in the Figure C (above). To do this, align the cover with the guide on the back of the remote control. Then, press the cover until it "snaps" into place.
5.It is recommended to refer to the Remote Control Overview section that begins on page