RT-10

Setup Menus

Audio1 A2 Video1 V2 Language General

1Setup Navigator

2

Amp Connection

Sub-woofer Present

5

Not Present

! Sub-woofer is connected

to an amplifier

 

 

 

 

 

 

 

 

 

Move

ENTER

Select

SETUP

Exit

Audio1 A2 Video1 V2 Language General

1Setup Navigator

Dolby Digital

2Dolby Digital/DTS

Amp Connection

Dolby Digital/MPEG

Digital Jack

Dolby D/DTS/MPEG

 

 

5PCM

6

Not Connected

! Compatible with Dolby Digital

 

 

 

 

 

Move

ENTER

Select

SETUP

Exit

Sub-woofer

Present, Not Present

Indicates the presence or absence of a subwoofer. When Present is selected, the RT-10 passes subwoofer signals (LFE) to the Sub analog audio output connector. When Not Present is selected, the RT-10 does not redirect low-frequency signals to other analog audio output connectors.

The Sub-woofer prompt is associated with the Audio2 tab Speaker Setting option, which can be used to set speaker sizes and distances.

Digital Jack

Refer to the table on page 3-3

Controls digital audio output format when the RT-10 is using the digital audio output connector. Select Not Connected if the RT-10 is not using the digital audio output connector.

Select the setting that includes all digital audio sources with which the associated component is compatible. The RT-10 will convert all other digital audio signals to PCM signals before passing them to the associated component. With the exception of the Not

Connected setting, all Digital Jack prompt settings assume the associated component is compatible with PCM signals.

For example, the MC-12 and MC-8 Digital Controllers are compatible with Dolby Digital, DTS, and PCM digital audio sources. If the RT-10 is connected to one of these components, select the Dolby Digital/DTS setting. The RT-10 will pass Dolby Digital, DTS, and PCM signals directly to the MC-12 or MC-8. The RT-10 will convert all other digital audio signals (i.e. MPEG) to PCM before passing them to the MC-12 or MC-8.

Associated components that are NOT compatible with DTS sources will output DTS noise when all of the following conditions are met:

•A DTS source is present.

•The Digital Jack prompt is set to Dolby Digital/DTS or Dolby D/DTS/MPEG OR the DTS Out parameter is set to DTS.

. . . Setup Navigator continues on page 3-8

3-7