Getting Started

Lexicon

Installation Considerations (continued from page 1-3)DO NOT . . .

•Install the RT-10 on a surface that is unstable or unable to support all four of its feet (unless the RT-10 is installed in an equipment rack).

•Stack the RT-10 directly above heat-producing components such as power amplifiers and other stereo equipment that generate heat during use. Avoid installing the RT-10 near radiators and other heat-producing appliances.

•Expose the RT-10 to high temperatures, direct sunlight, humidity, steam, smoke, dampness, and excessive dust.

•Install the RT-10 near unshielded TV or FM antennas, cable TV decoders, and other RF emitting devices that might cause interference. Replace unshielded cables with shielded cables whenever possible.

•Prevent proper cooling. Do not block or cover ventilation slots and openings on the RT-10 with items such as newspapers, cloths, and curtains. Do not place the RT-10 on a thick carpet, bed, sofa, or fabric with a thick pile.

•Expose the RT-10 to sudden or drastic temperature changes, as this might cause condensation to form on the RT-10 lens. Although condensation will not damage the RT-10, it might temporarily impair performance. If this occurs, allow at least 1 hour for condensation to evaporate before attempting to load a disc.

•Obstruct the front panel display remote control sensor when the RT-10 is not using the IR input connector. If the RT-10 is not using the IR IN connector, the remote control must be in line- of-sight with the front panel display remote control sensor. Refer to page 2-14 for more information.

Note:

The RT-10 lens should not become dirty or damaged from regular use. However, if malfunction occurs, contact an authorized Lexicon dealer for assistance. Do not attempt to clean the lens with a commercially available DVD or CD lens cleaner, as some of these products might damage the RT-10 lens.

DVD-V REGIONS

The map shown below indicates DVD-V region codes for all areas of the world. All DVD-Vs are marked with a region code, which is often located on the disc packaging. The RT-10 rear panel is also marked with a region code. The RT-10 is compatible with discs marked with this same region code or with the ALL region code. The RT-10 is not compatible with discs marked with other region codes.

1

2

 

 

5

 

 

 

6

1

 

 

2

 

 

 

3

4

5

5

 

 

 

 

2

 

4

1-4