Setup Menus

Lexicon

Note:

The Setup menu should be used to configure the RT-10 before attempting disc playback.

CONTROL BAR

When a Setup menu screen is open, a control bar similar to the one shown below appears at the bottom of the on-screen display to indicate which remote control buttons are available for the open screen. These buttons appear on the control bar with a one-word description of their associated commands.

For instance, the control bar shown below indicates that the SETUP button, ENTER button, and  and  arrows are available for the open screen. The SETUP button can be used to "Exit" or close the open screen. The ENTER button can be used to "Select" the highlighted setting. And, the  and  arrows can be used to "Move" or navigate around the screen.

No matter which menu screen is open, the , , , and  arrows will appear on the control bar. However, only the lighter- colored arrows can be used to navigate around the screen.

Move

ENTER

Select

SETUP

Exit

SETUP NAVIGATOR

The Setup Navigator is a convenient tool that can be used to configure basic RT-10 settings without navigating through the entire Setup menu. It presents a series of prompts that provide step-by-step guidance through the process of selecting minimum audio, video, and language settings.

With the exception of the last Setup Navigator prompt, all prompts represent a simplified version of actual Setup menu parameters. For instance, the TV Type prompt (3-5) is associated with the Video1 tab TV Screen parameter (3-25). The table on the next page lists all Setup Navigator prompts, along with their possible settings and associated Setup menu parameters.

When the RT-10 is first powered on, the Setup Navigator opens on the on-screen display whenever the remote control SETUP button is pressed while the RT-10 is in stop mode. Otherwise, the Setup Navigator can be opened from the Setup menu General tab (3-42). Refer to the Setup Navigator prompt description on page 3-4 for more information.

To open the Setup Navigator:

1.Press the Stop button to activate stop mode. In some cases, the Stop button must be pressed twice in succession to activate stop mode.

2.When stop mode is activated, press the remote control SETUP button to open the Setup Navigator. If the Setup Navigator does not open, it must be opened from the Setup menu General tab (3-42).

3-2