RT-10

Setup Menus

•Eliminate extraneous noises in the listening space such as conversations, air conditioners, and sounds that filter in through open doors and windows.

•Remove objects (including people) that obstruct the line-of- sight path between the SPL meter and the speaker being measured.

•Output levels should be calibrated to be consistent from the primary listening position. Place the SPL meter at the approximate spot where the listener’s head will be during listening.

To set variable output levels:

1.When the Gain Setting screen opens, press the remote control  arrow to open the Test Tone screen shown on page 3-21.

2.When the Test Tone screen opens, press the  and  arrows to highlight the desired parameter.

• Test Tone parameters cannot be adjusted when the disc drawer is open, the Audio Out parameter or Setup Navigator Analog Jacks prompt is set to 2 Channel, or the RT-10 is in playback, pause, or resume mode. (The RT-10 must be in stop mode.)

3.When the desired parameter is highlighted, press the  and  arrows to cycle through the Auto, On, and Off settings.

• Select Auto to set all test tone parameters to Auto. Test tones will pass through each channel when the associated Gain Setting screen parameter is highlighted.

• Select On to activate a test tone for the associated channel. A test tone will pass through the associated channel when the corresponding Gain Setting screen parameter is highlighted.

•Select Off to deactivate a test tone for the associated channel. No test tone will pass through the associated channel.

4.Repeat steps 2 and 3 until all desired test tones have been activated or deactivated.

5.When all desired test tones have been activated, press the  and  arrows to highlight the Test Tone option at the top of the screen. Then, press the  arrow to reopen the Gain Setting screen.

6.When the Gain Setting screen opens, press the  and  arrows to highlight the desired parameter. If the corresponding test tone parameter has been set to Auto or On, a test tone will pass through the associated channel.

•To hear the test tone again, press the  and  arrows to reselect the parameter.

Note:

Test tones automatically mute when the Lexicon screen saver appears on the on-screen display. To avoid this, set the Screen Saver parameter (3-28) to Off while variable output levels are calibrated. Test tones also mute when playback mode is activated.

7.When the desired parameter is highlighted, press the  and  arrows to cycle through available settings.

8.When the desired setting is selected, press the  and  arrows to highlight the Gain Setting option at the top of the on-screen display. Then, press the remote control ENTER button to return to the Setup menu.

3-23