Return to Section TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
POWER MODULE TEST (continued)
FIGURE F.25 – POWER MODULE CAPACITOR LEADS
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TEST PROCEDURE
1.This procedure must be performed with the engine off.
2.Remove the left and right case sides.
3.Perform the Power Module Capacitor
Discharge Procedure.
4.Using the 7/16" wrench, remove the positive and negative strap leads from the power module capacitor terminals. See Figure F.25. Remove the leads from both the left and right side modules.
POWER MODULE (CHOPPER PC BOARD)
REMOVE LEADS
NOTE: The left side module will also have the bleeder resistor leads attached. Label and remove them also.
Return to Section TOC
Return to Master TOC
