
Return to Section TOC
Return to Section TOC
TOC
Return to Master TOC
Return to Master TOC
TOC
TROUBLESHOOTING & REPAIR
POWER MODULE/OUTPUT RECTIFIER BRIDGE ASSEMBLY
REMOVAL AND REPLACEMENT (continued)
FIGURE F.39 – CONTROL PANEL REMOVAL
SCREWS 
FRONT
CONTROL
PANEL
SCREW
TEST PROCEDURE
1.Turn the engine off.
2.Using the 3/8" wrench, remove the screws holding the front control panel to the case top and sides. See Figure F.39. (There are two screws on the top and one screw on each side.)
3.Carefully lower the front control panel.
4.Using the 3/8" wrench, remove the front left and right side panels.
5.Perform the Output Panel Removal
Procedure.
6.Perform the Power Module Capacitor
Discharge Procedure.
7.Optional: With the 7/16" wrench, remove the ground wire from the output panel assembly. If the ground wire is not in the way, it can remain attached.
Return to Section TOC
Return to Master TOC