Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
STATOR/ROTOR REMOVAL AND REPLACEMENT
WARNING
Service and repair should be performed by only Lincoln Electric factory trained personnel. Unauthorized repairs performed on this equipment may result in danger to the technician or machine operator and will invalidate your factory warranty. For your safety and to avoid electrical shock, please observe all safety notes and precautions detailed throughout this manual.
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, contact the Lincoln Electric Service Department for electrical trou- bleshooting assistance before you proceed. Call
TEST DESCRIPTION
The following procedure will aid the technician in removing and replacing the Commander 300 stator and rotor.
MATERIALS NEEDED
3/8" Wrench | Slot head screw driver |
7/16" Wrench | Phillips head screw driver |
1/2" Wrench | Gear puller (small) |
3/4" Wrench | Hoist |
1" Open end wrench | Feeler gauge (for air gap check) |
|
This procedure should take approximately 51⁄2 hours to perform.
