Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
OUTPUT RECTIFIER BRIDGE TEST (continued)
FIGURE F.22 – FRONT CONTROL PANEL REMOVAL
SCREWS 
FRONT
CONTROL
PANEL
SCREW
Return to Section TOC
Return to Master TOC
TEST PROCEDURE
1.Turn the engine off.
2.Using the 3/8" wrench remove the screws holding the front control panel to the case top and sides. See Figure F.22. (There are two screws on the top and one screw on each side.)
3.Carefully lower the front control panel.
4.Using the 3/8" wrench, remove the front left and right side panels.
5.Perform the Power Module Capacitor
Discharge Procedure.
6.Using the 3/4" wrench, remove the internal leads from the output terminals. Insulate the leads.
Return to Section TOC
Return to Master TOC
